The factory security functions are managed by the Body Control Module (BCM) where we need to make the connections. The BCM is located under the drivers dash.
You will need plug c3 and c4
Plug C3 Light Green
C4 is Black
Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches
Set SW1 (8 switches) as following
| DIP SWITCHES (SW1) | |||||||
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| off | off | off | on | on | off | off | on |
Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.
To install the NEWROCKIES PRO Module, connect it as following:
|
Pro Bypass |
Vehicle Wires |
|
RED |
Splice into BROWN wire at the BCM Connector C3 Pin 5 |
|
BLK |
Splice into BLACK with WHITE stripe wire at the BCM connector C4 Pin 26. |
|
WHT |
Splice into PINK wire at the BCM Connector C3 Pin 6 |
|
GRN |
Unconnected |
|
YEL |
Splice into the Pink wire at BCM connector C3 pin 15 |
|
BLU |
unconnected |
|
BRN |
Cut WHITE with a BLACK stripe wire at the BCM connector C3 Pin 22 a couple inches from connector so you have room to connect the brown wire to the wire coming from the connector |
Relearn Procedure
- Turn ON the ignition, with the engine OFF.
- Attempt to start the engine, then release the key to ON, vehicle will not start.
- Observe the SECURITY telltale. After approximately 10 minutes, the telltale will turn OFF.
- Turn OFF the ignition, and wait 5 seconds.
- Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes. The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
- Important: The vehicle learns the password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.
- Start the engine. The vehicle has now learned the password.
The installation is completed.
0 Comments