How to reach the TDM and install the PRO Full Bypass
The TDM is under the right side of the dash (passenger side, behind glovebox)
- Remove the instrument panel Glove Box there are a four 7mm screws in the hinge that hold it on.
- Remove the PASS-Key® II module (TDM) from the dash (1) It is directly above the heater box with one 10mm nut holding it to the dash the plug on it is green.
- Disconnect the electrical connection.
GREEN TDM Connector
If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations):
Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.
Set SW1 (8 switches) as following:
| DIP SWITCHES (SW1) | |||||||
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| off | off | on | off | on | off | on | off |
Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.
To install the NEWROCKIES PRO Module, connect it as following (the TDM should be left unplugged as it is not needed anymore):
|
PRO Bypass |
Car Wires |
|
RED |
Attach to the Pink or Pink with a black stripe in pin A2 |
|
BLK |
Attach to the Black in pin B5 |
|
PPL |
Attach to the Yellow with a black stripe in pin A4 |
|
GRN |
Attach to the Blue wire in A3 |
|
YEL |
unconnected |
|
WHITE |
unconnected |
|
BRN |
unconnected |
IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.
The installation is completed.
0 Comments