First we need to gain access to the Theft Deterrent Controller (TDC).
The module is located on the mounting bracket right of the brake pedal.
Unplug the theft deterrent controller and Connect the Pro bypass Module as follows.
If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations):
Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.
Set SW1 (8 switches) as following:
|
Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.
To install the NEWROCKIES PRO Module, connect it as following (the TDC should be left unplugged as it is not needed anymore):
PRO Bypass |
Car Wires |
RED |
Attach to the Pin K, Pink Black |
BLK |
Attach to Pin A Black |
PPL |
Attach to Pin E Dark Blue |
GRN |
unconnected |
YEL |
unconnected |
WHT |
unconnected |
BRN |
unconnected |
Leave the TDC unplugged
IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.
The installation is completed.
0 Comments