The Theft Deterrent Module on this car is integral to the Central Control Module or CCM which is in the trunk on the back of the rear seat.
There are 2 connectors.
C1
and C2
If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations):
Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.
Set SW1 (8 switches) as following:
| DIP SWITCHES (SW1) | |||||||
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| off | off | on | off | on | off | on | off |
Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.
To install the NEWROCKIES PRO Module, connect it as following:
|
PRO Bypass |
Car Wires |
|
RED |
Splice to the PINK wire at the connector C1 pin B9 |
|
BLK |
Splice to the BLACK/WHITE wire at the connector C2 pin C1 |
|
PPL |
Splice to the YELLOW with a BLACK stripe at the Connector C2 pin D13 |
|
GRN |
cut the Dark BLUE wire leaving the CCM connector C1, Pin B1, and attach this wire to the wire leading away from the module. |
|
YEL |
Not Used |
|
WHT |
Not Used |
|
BRN |
Not Used |
IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.
The installation is completed.
0 Comments