The Theft Deterrent Module/Passkey Decoder Module or TDM/PDM is under the dash, right side.
-Remove the glove box, Disconnect the wiring from the retainer, Remove the Relay center
-Remove the 3 screws from the relay bracket, Remove the relay center bracket.
-Remove the 2 Module screws, Disconnect the electrical connector and remove the module.
Unplug and remove the Passkey decoder module. It has a green plug. The PRO Full Bypass replaces the PDM.
If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations):
Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.
Set SW1 (8 switches) as following:
|
|||||||||||||||||||||||||||||||
Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.
To install the NEWROCKIES PRO Module, connect it as following (the TDM/PDM should be left unplugged as it is not needed anymore):
|
PRO Bypass |
Car Wires |
|
RED |
Attach to the PINK with a BLACK stripe at the TDM/PDM Connector Pin A1 |
|
BLK |
Attach to the BLACK with a WHITE stripe at the TDM/PDM connector Pin B1 |
|
PPL |
Attach to the YELLOW wire with a BLACK Stripe at the TDM/PDM connector Pin A3 |
|
GRN |
Attach to the DARK BLUE wire at the TDM/PDM connector Pin A2 |
|
YEL |
Not used. |
|
WHITE |
Not Used |
|
BRN |
Not used |
IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.
The installation is completed.
0 Comments