The Theft Deterrent Module (TDM) is on a board with several other components behind the right side of the dash.(1)
Unplug and leave unplugged the PassKey Decoder Module (#3). The Full Bypass will replace it.
If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations):
Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.
Set SW1 (8 switches) as following:
| DIP SWITCHES (SW1) | |||||||
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| off | off | on | off | on | off | off | on |
Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.
To install the NEWROCKIES PRO Module, connect it as following (the TDM should be left unplugged as it is not needed anymore):
|
PRO Bypass |
Car Wires |
|
RED |
Splice to pin K (RED/BLACK) of the TDM connector |
|
BLK |
Splice to Pin A (BLACK) of the TDM connector |
|
PPL |
Cut wire at pin E (BLUE) of the TDM connector and attach wire to the side away from the (TDM) connector |
|
GRN |
Not used |
|
YEL |
Not used |
|
WHT |
Not Used |
|
BRN |
Not used |
IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.
The installation is completed
0 Comments