How to reach the TDM and install the PRO Full Bypass
The TDM is under the right side of the dash (passenger side, behind glovebox)
- Remove the instrument panel Glove Box.
- Remove the relay center and the 3 screws from the relay bracket.
- Remove the relay center bracket and then the 2 screws to remove the PASS-Key® II module (TDM) from the bracket (1).
- Disconnect the electrical connection(s) (unplug and remove the TDM)
TDM Connector
Unplug the TDM and leave it unplugged, the PRO module replaces the TDM.
If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations):
Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.
Set SW1 (8 switches) as following:
| DIP SWITCHES (SW1) | |||||||
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| off | off | on | off | on | off | on | off |
Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.
To install the NEWROCKIES PRO Module, connect it as following (the TDM should be left unplugged as it is not needed anymore):
If you have the above connector on the TDM, connect as following:
|
PRO Bypass |
Car Wires |
|
RED |
Attach to the Pink or Pink with a black stripe in pin A2 |
|
BLK |
Attach to the Black in pin B5 |
|
PPL |
Attach to the Yellow with a black stripe in pin A4 |
|
GRN |
Attach to the Blue wire in A3 |
|
YEL |
unconnected |
|
WHT |
Not Used |
|
BRN |
unconnected |
In some cases the TDM has a different connector (see below) and wiring.
If this is your case, then use the following connections instead:
|
PRO Bypass |
Car Wires |
|
RED |
Attach to the PDM Connector pin A1 (PNK or PPL/WHT) |
|
BLK |
Attach to the PDM Connector Pin B1 (BLK or BLK/WHT) |
|
PPL |
Attach to the PDM Connector pin A3 (YEL/BLK or BLK/YEL) |
|
GRN |
Attach to the PDM Connector pin A2 (DK BLUE) |
|
YEL |
unconnected |
|
WHT |
Not Used |
|
BRN |
unconnected |
IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.
The installation is completed.
0 Comments