1990-1992 Oldsmobile Toronado

How to reach the TDM and install the VATS Passkey Bypass

 

The TDM module is behind the left side of the dash, left of the steering column.

1990-1992_Oldsmobile_Toronado1.jpg

 

 

1990-1992_Oldsmobile_Toronado2.jpg

TDM Connector

 

 

Unplug the TDM and leave it unplugged, the PRO module replaces the TDM.

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
off off on off on off off on

 

Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.

 

To install the NEWROCKIES PRO Module, connect it as following (the TDM should be left unplugged as it is not needed anymore):

 

PRO Bypass        

Car Wires

RED

on TDM pin A1 (PNK/BLK)

BLK

on both TDM pin B1 (BLK/WHT)

PPL

on TDM pin A3 (YEL/BLK)

GRN

on TDM pin A2 (DK BLUE)

YEL

unconnected

WHT

unconnected

BRN

unconnected

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.