To install the pro bypass module we will need to access the RKE module behind the right rear side seat attached to the in-structure
|
1.1. |
Disengage seat cushion by pushing rearward, then upward at 2 front retaining locations to release the rear cushion from the retainer. |
|
1.2. |
Slide the cushion from under the seat back guiding the seat belt buckle through the seat cushion and remove the seat cushion. |
|
1.4. |
Lower rear seat back. |
|
1.5. |
Remove body lock trim finish molding by pulling firmly, starting at the bottom of the molding to disengage clips. |
|
1.6. |
Slide molding out from under body lock pillar upper trim finish molding. |
- Disconnect RKE module connector.
- Pull firmly on RKE module from the top to bottom, to disengage double side tape retainer.
- Remove RKE module.
If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations):
Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.
Set SW1 (8 switches) as following:
| DIP SWITCHES (SW1) | |||||||
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| off | off | on | off | on | off | on | off |
Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.
To install the NEWROCKIES PRO Module, connect it as following:
|
PRO Bypass |
Car Wires |
|
RED |
Splice into the RKE connector Terminal J, Pink wire |
|
BLK |
Splice into the RKE connector Terminal N Black wire |
|
PPL |
Cut the wire on Terminal D Yel/Blk wire and connect the PPL wire of the PRO bypass to it toward the harness going away from the RKE module plug
|
|
GRN |
Not Used |
|
YEL |
Not Used |
|
WHT |
Not Used |
|
BRN |
Not Used |
Plug the RKE module back to it’s connector.
IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.
The installation is completed.
0 Comments