The BCM is is under the left side of the dash
There are 4 electrical connectors on the BCM we need (C1 BLUE, C2 BLUE)
C2 Connector Purple
C1 Connector blue
If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations):
Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.
Set SW1 (8 switches) as following:
| DIP SWITCHES (SW1) | |||||||
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| on | off | off | off | off | on | on | off |
Set SW2 (10 switches) as following:
| DIP SWITCHES (SW2) | |||||||||
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 |
| off | off | off | off | off | off | off | on | off | off |
To install the NEWROCKIES PRO Module, connect it as following:
|
Pro Bypass |
Vehicle Wires |
|
RED & WHT |
Splice in to the PINK wire going into the BCM connector C1 Pin J |
|
BLK |
Splice into the BLACK wire going into the BCM Connector C1 Pin B |
|
PPL |
Unconnected |
|
GRN |
Unconnected |
|
YEL |
Cut the Yellow wire on BCM connector C2, Pin B3. Tape the side that goes toward the car and connect the YEL wire of the PRO module to the other side going into the BCM connector. |
|
BRN |
Slice into the BLACK wire going into BCM Connector C2 Pin B4 |
Perform the re-learning procedure
- Turn ON the ignition, with the engine OFF.
- Attempt to start the engine, then release the key to ON (vehicle will not start).
- Observe the SECURITY light, after approximately 11 minutes the light will turn OFF.
- Turn OFF the ignition, and wait 10 seconds.
- Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes ( the vehicle
- is now ready to relearn the Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK).
Start the engine (the vehicle has now learned the Sensor Data Code and/or password).
IMPORTANT: If your car still does not start, please follow the troubleshooting directions for Passlock 1/2 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.
The installation is completed.
0 Comments