How to reach the BCM and install the PRO Bypass
Location of the BCM is under the right side of the dash by the blower motor.
You will need to remove the black panel above the passengers feet to be able to see the BCM
There are 3 electrical connectors on the BCM (C1, C2 and C3)
Connector C2 is the Grey 24 pin connector.
C3, the Pink one.
Cut the wire on BCM C2 Pin B6 (YEL).
If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations):
Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.
Set SW1 (8 switches) as following:
| DIP SWITCHES (SW1) | |||||||
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| on | off | off | off | off | on | on | off |
Set SW2 (10 switches) as following:
| DIP SWITCHES (SW2) | |||||||||
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 |
| off | off | off | off | off | off | off | on | off | off |
To install the NEWROCKIES PRO Module, connect it as following:
|
Pro Bypass |
Car Wires |
|
RED & WHITE wires |
Splice with the PINK wire at BCM C2 Pin B9 |
|
BLK |
Splice into the BLACK with a WHITE stripe at the pink C3 connector pin A10. |
|
PPL |
Unconnected |
|
GRN |
Unconnected |
|
YEL |
Connect to the YELLOW wire at BCM C2 Pin B6 toward the BCM connector |
|
BRN |
Splice with the BLACK wire at BCM C2 Pin A6 |
RED AND WHITE CONNECTED TOGETHER AT THE LOCATION OF THE RED BELOW
Perform the re-learning procedure
- Turn ON the ignition, with the engine OFF.
- Attempt to start the engine, then release the key to ON (vehicle will not start).
- Observe the SECURITY light, after approximately 10 minutes the light will turn OFF.
- Turn OFF the ignition, and wait 10 seconds.
- Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes
- The vehicle is now ready to relearn the Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
- Start the engine (the vehicle has now learned the Sensor Data Code and/or password).
IMPORTANT: If your car still does not start, please follow the troubleshooting directions for Passlock 1/2 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.
The installation is completed.
0 Comments