Locate the BCM as follows
The BODY CONTROL MODULE is under the dash left side above the parking brake pedal area.
To get to it, remove the 10mm bolt that holds the parking brake release lever to the trim.
Remove the 2 philips screws from the bottom.
Remove the left dash fuse block cover.
Ensure the ignition switch is in the OFF position.
We need connector C1 Light green 27 pins
and C3 light blue 25 pins.
Both show the end that goes into the BCM so be sure to count the opposite for looking at the back.
Make sure to cut 3-4 inches back from the BODY CONTROL MODULE.
If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations):
Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.
Set SW1 (8 switches) as following:
| DIP SWITCHES (SW1) | |||||||
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| off | off | off | on | on | off | off | on |
Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.
To install the NEWROCKIES PRO Module, connect it as following:
|
Pro Bypass |
Vehicle Wires |
|
RED |
Splice into BROWN wire at the BCM Connector C1 Pin 21 |
|
BLK |
Splice into BLACK with WHITE stripe wire at the BCM connector C3 Pin 1. |
|
White |
Splice into the PINK wire at BCM connector C1 pin 14 |
|
GRN |
Not Used |
|
YEL |
Splice into the Pink with Black wire at BCM connector C1 pin 2 |
|
BLU |
Not Used |
|
BRN |
Cut White wire at the BCM connector C1 Pin 4 a couple inches from connector so you have room to connect the brown wire to the wire coming from the connector |
30 MINUTE RELEARN PROCEDURE
- Turn ON the ignition, with the engine OFF.
- Attempt to start the engine, then release the key to ON, vehicle will not start.
- Observe the SECURITY telltale. After approximately 10 minutes, the telltale will turn OFF.
- Turn OFF the ignition, and wait 5 seconds.
- Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes. The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
- Important: The vehicle learns the password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.
- Start the engine. The vehicle has now learned the password.
THIS TRUCK HAS 2 SETTINGS CHECK TROUBLESHOOTERS FOR THE 2
IMPORTANT: If your car still does not start, please follow the troubleshooting directions for Passlock 300 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.
0 Comments