2000-2005 Chevrolet Impala, Monte Carlo

 

The BCM is under the dash, far left above the parking brake pedal.

2000-2005_Chevrolet_Impala1.gif

There are 3 electrical connectors on the BCM (C1 24 pin pink, C2 24 pin grey, C3 16 pin grey) This view is looking into the end that goes into the BODY CONTROL MODULE, so reverse it with the release tab on top. The top row is A.

C1 Pink

2000-2005_Chevrolet_Impala2.gif

 

C2 Grey

2000-2005_Chevrolet_Impala3.gif

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
on off off off off on on off

 

Set SW2 (10 switches) as following:

DIP SWITCHES (SW2)
1 2 3 4 5 6 7 8 9 10
off off off off off off off on off off

 

To install the NEWROCKIES PRO Module, connect it as following:

 

Pro Bypass

Vehicle  Wires

RED and WHITE wires       

Splice into PURPLE wire at the BCM Connector C1 Pin A12

BLK

Splice into the BLACK wire  at the BCM connector C1 Pin A7.

PPL

Unconnected

GRN

Unconnected

YEL

Cut the YELLOW wire going into BCM connector C2 Pin A3 (YEL) several inches back and connect the YEL wire of the PRO bypass to it toward the BCM connector – tape the end going toward the vehicle.

BRN

Splice into the BLACK wire at the BCM connector C1 Pin B12

 

 

Perform the re-learning procedure

  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to start the engine, then release the key to ON (vehicle will not start).
  3. Observe the SECURITY light, after approximately 10 minutes the light will turn OFF.
  4. Turn OFF the ignition, and wait 10 seconds.
  5. Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes ( the vehicle
  6. is now ready to relearn the Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK).

Start the engine (the vehicle has now learned the Sensor Data Code and/or password).

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for Passlock 1/2 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.