We need to locate the BCM under the driverside of the dash
We need plug C1
Plug is LT/GN
If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations):
Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.
Set SW1 (8 switches) as following:
| DIP SWITCHES (SW1) | |||||||
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| off | off | off | on | on | off | off | on |
Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.
To install the NEWROCKIES PRO Module, connect it as following:
| Pro Bypass | Vehicle Wires |
|
RED |
Splice into BROWN wire at the BCM Connector C1 Pin 21 |
|
BLK |
Splice black wire into BLACK with WHITE stripe wire at the BCM connector C1 Pin 8. |
|
WHITE |
Splice into the PINK wire at BCM connector C1 Pin 14 |
|
GRN |
Unconnected |
|
YEL |
Splice into the WHITE wire at BCM connector C1 pin 2 |
|
PPL |
Unconnected |
|
BRN |
Cut WHITE with BLACK stripe wire at the BCM connector C1 in 4 a couple inches from connector so you have room to connect the brown wire to the wire coming from the connector |
If the car starts on the first try this is not needed
Perform the re-learning procedure
- Turn ON the ignition, with the engine OFF.
- Attempt to start the engine, then release the key to ON (vehicle will not start).
- Observe the SECURITY light, after approximately 10 minutes the light will turn OFF.
- Turn OFF the ignition, and wait 10 seconds.
- Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes ( the vehicle
- is now ready to relearn the Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK).
Start the engine (the vehicle has now learned the Sensor Data Code and/or password).
IMPORTANT: If your car still does not start, please follow the troubleshooting directions for Passlock 300 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.
0 Comments