Locate the BCM and install the PRO Bypass Module
The BCM is under the cluster and above the steering column. The knee bolster must come off, much of the trim on the dash and the cluster must come out to get at this to install the module.
There are 6 electrical connectors on the BCM (C1, C2, C3, C4, C5, C6) The connectors we need are C2 which is grey and C3 which is brown and C4 which is light blue. All 3 have the same configuration and are a 24 pin connector. Disconnect the Lt Blue connector first.
If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations):
Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.
Set SW1 (8 switches) as following:
| DIP SWITCHES (SW1) | |||||||
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| on | off | off | off | off | on | on | off |
Set SW2 (10 switches) as following:
| DIP SWITCHES (SW2) | |||||||||
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 |
| off | off | off | off | off | off | off | on | off | off |
To install the NEWROCKIES PRO Module, connect it as following:
|
Pro Bypass |
Car Wires |
|
RED & WHITE wires |
Splice into PINK wire at the BCM Connector C4 Pin A4 |
|
BLK |
Splice into the BLACK with a WHITE stripe at the BCM connector C2 Pin B6. |
|
PPL |
Unconnected |
|
GRN |
Unconnected |
|
YEL |
Cut the YELLOW wire on BCM C3 Pin A6 and connect the YEL wire of the bypass to it on the side of the BCM connector. Tape the other side. |
|
BRN |
Splice into the BLACK wire at the BCM connector C2 Pin B7 |
Perform the re-learning procedure
- Turn ON the ignition, with the engine OFF.
- Attempt to start the engine, then release the key to ON (vehicle will not start).
- Observe the SECURITY light, after approximately 10 minutes the light will turn OFF.
- Turn OFF the ignition, and wait 10 seconds.
- Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes ( the vehicle
- is now ready to relearn the Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK).
Important: The vehicle relearns Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.
Start the engine (the vehicle has now learned the Sensor Data Code and/or password).
IMPORTANT: If your car still does not start, please follow the troubleshooting directions for Passlock 1/2 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.
The installation is completed.
0 Comments