1995-1996 Buick Regal

the TDM is under the right side of the dash (passenger side, behind glovebox).

You will need to look up into glove box opening on the cross car beam for the module bracket.

1995-1996_Buick_Regal1.png

1995-1996_Buick_Regal2.gif

TDM Connector

 

Unplug the TDM and leave it unplugged, the PRO module replaces the TDM.

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
off off on off on off on off

 

Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.

 

To install the NEWROCKIES PRO Module, connect it as following (the TDM should be left unplugged as it is not needed anymore):

 

PRO Bypass         

Car Wires

RED

Attach to the TDM Connector pin A2 (PNK/BLK)

BLK

Attach to the TDM Connector Pin B5 (BLK)

PPL

Attach to the TDM Connector pin A4 (YEL/BLK)

GRN

Attach to the TDM Connector  pin A3 (DK BLUE)

YEL

unconnected

WHT

unconnected

BRN

unconnected

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.