1986-1989 Chevrolet Corvette

The TDM (VATS Module) can be found under the right side of the dash.

1986-1989_Chevrolet_Corvette_1.png

 

1986-1989_Chevrolet_Corvette_2.jpg

 

Unplug the TDM and leave it unplugged, the PRO module replaces the TDM.

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
off off on off on off off on

 

Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.

 

To install the NEWROCKIES PRO Module, connect it as following (the TDM should be left unplugged as it is not needed anymore):

 

PRO Bypass

Car Wires

RED

Attach to the PINK with a BLACK stripe at the TDM Connector Pin A1 or S

BLK

Attach to the BLACK wire at the TDM connector Pin B1 or L

PPL

Attach to the DARK GREEN wire at the TDM connector Pin A3 or V

GRN

Attach to the DARK BLUE wire at the TDM connector Pin A2 or P

YEL

Not used.

WHT

Not Used

BRN

Not used

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.