How to reach the Passkey Decoder module (PDM) and install the PRO Full Bypass.
The Passkey Decoder module is in the trunk.
The Passkey decoder module (PDM) Connector is as following:
Unplug and remove (or leave unplugged) the Passkey decoder module.
If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations):
Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.
Set SW1 (8 switches) as following:
| DIP SWITCHES (SW1) | |||||||
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| off | off | on | off | on | off | on | off |
Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.
To install the NEWROCKIES PRO Module, connect it as following (the PDM should be left unplugged as it is not needed anymore):
|
PRO Bypass |
Car Wires |
|
RED |
Attach to the PINK or PPL/WHT at the PDM Connector Pin A2 |
|
BLK |
Attach to the BLACK with a WHITE stripe at the PDM connector Pin B5 |
|
PPL |
Attach to the (YEL/BLK or BLK/YEL) at the PDM connector Pin A4 |
|
GRN |
Attach to the DARK BLUE wire at the TDM connector Pin A3 |
|
YEL |
Not used. |
|
WHT |
Not Used |
|
BRN |
Not used |
IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.
The installation is completed.
0 Comments