How to reach the Theft Deterrent Module (TDM) and install the PRO Full Bypass
TDM is under the Left side of the dash to the left of the steering column
- Disconnect the electrical connections for both modules.
- Make the electrical connectors as instructed below but plug the Theft Deterrent module back in.
If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations):
Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.
Set SW1 (8 switches) as following:
| DIP SWITCHES (SW1) | |||||||
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| off | off | on | off | on | off | off | on |
Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.
To install the NEWROCKIES PRO Module, connect it as following:
|
Pro Bypass |
Vehicle Wires |
|
RED |
Splice to the TDM Connector pin K ( PNK/BLK) |
|
BLK |
Splice to the TDM Connector Pin A ( BLK/WHT) |
|
WHT |
Not Used |
|
GRN |
Not Used |
|
YEL |
Not Used |
|
PPL |
Cut and attach to the TDM Connector pin E only to the side away from the plug tape remaining side ( BLK/YEL) |
|
BRN |
Not Used |
ON TERMINAL D CUT THE DK-GRN/WHT WIRE AND TAPE OFF THE ENDS
AT THIS TIME plug in the original TDM.
IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.
0 Comments