1993 Buick Riviera

How to reach the PassKey Decoder Module (PDM) and install the PRO Full  Bypass

 

The PDM is under the Left side of the dash above the parking brake area.

 

1993_Buick_Riviera1.jpg

 

  1. Remove the PASS-Key® I module (PDM)  from the bracket (1).
  2. Disconnect the electrical connection(s).

 

 

1993_Buick_Riviera2.jpg

 

                       PDM Connector

 

Unplug the PDM and leave it unplugged, the PRO module replaces the TDM.

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
off off on off on off on off

 

Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.

 

To install the NEWROCKIES PRO Module, connect it as following (the PDM should be left unplugged as it is not needed anymore):

 

Pro Bypass        

Car Wires

RED

Attach to the Pink or Pink with a black stripe in pin A2

BLK

Attach to the Black or Black with White stripe in pin B5

PPL

Attach to the Yellow with a black stripe in pin A4

GRN

Attach to the Dark Blue wire in A3

YEL

unconnected

WHT

unconnected

BRN

unconnected

 

Do NOT plug back the original PDM. The PRO Full Bypass replaces the TDM.

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.