The TDM (Theft Deterrent Module) is above and left of the brake pedal under the dash.

 

 

Option 1: Installation at TDM location

                               TDM Connector

 

 

Unplug the TDM and leave it unplugged, the PRO module replaces the TDM.

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1	2	3	4	5	6	7	8
off	off	on	off	on	off	on	off

 

Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.

 

To install the NEWROCKIES PRO Module, connect it as following (the TDM should be left unplugged as it is not needed anymore):

 

Pro Bypass	Car Wires
RED & WHITE wires	Attach to the Pink  in pin A2
BLK	Attach to the Black with a White stripe in pin B5
PPL	Attach to the Yellow with a black stripe in pin A4
GRN	Attach to the Blue wire in A3
YEL	unconnected
WHT	unconnected
BRN	unconnected

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Option 2: Installation directly at ECM

This is to use in case your car is a project car and no TDM is installed.

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1	2	3	4	5	6	7	8
off	off	on	off	on	off	on	off

 

Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.

 

To install the NEWROCKIES PRO Module, connect it as following:

 

PRO Bypass	Car Wires
RED	Splice to PCM Black connector B pin 30 PINK
BLK	Splice to PCM Red connector A Pin 2, Black with a White stripe.
PPL	Not used.
GRN	Attach to PCM Red connector A Pin 25, Dark Blue (make sure only the PRO Bypass is connected on this wire, so if the Dark Blue wire is present, cut it and connect the GRN (or BLU) of the PRO Bypass to it toward the ECM).
YEL	unconnected
BLU	unconnected
BRN	unconnected

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.