1993-1998 Oldsmobile Cutlass Supreme, Chevrolet Lumina, Monte Carlo 1994-1996 Pontiac Grand Prix 1995-1996 Buick Regal

The TDM is under the right side of the dash (passenger side, behind glove box). It is up in there, backwards on a bracket.

 

Remove the Glove Box, Then remove the Bolts that hold the Theft deterrent module bracket from the cross car beam, then remove the electrical connector and the module.

 

*****The Theft module has a GREEN Connector with 16 pins, 2 rows of 8 and is the only connector in the module. ******

1993-1998_Olds_Cutlass_Supreme1.png

1993-1998_Olds_Cutlass_Supreme2.gif

          GREEN 16 pin TDM Connector

 

Unplug the TDM and leave it unplugged, the PRO module replaces the TDM.

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1 2 3 4 5 6 7 8
off off on off on off on off

 

Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.

 

To install the NEWROCKIES PRO Module, connect it as following (the TDM should be left unplugged as it is not needed anymore):

PRO Bypass       

Car Wires

RED

Attach to the PINK wire at the connector A2

BLK

Attach to the BLACK wire at the conenctor B5

PPL

Attach to the YELLOW with a BLACK stripe at the Connector A4

GRN

Attach to the DARK BLUE wire at the connector A3

YEL

Not Used

WHT

Not Used

BRN

Not Used

 

Then connect the Relay connector and install the bracket back into the vehicle with the PRO Module attached to this bracket in place of the Theft Module. DO NOT plug back the original TDM, the PRO Full Bypass replaces the TDM.

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.

Have more questions? Submit a request

0 Comments

Article is closed for comments.