How to reach the TDM and install the PRO Full Bypass
The TDM is around the ignition cylinder so we will have to splice in at the base of the steering column, connector C201. - The Connector C201 is under the steering column, #4 below.
If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations):
Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.
Set SW1 (8 switches) as following:
| DIP SWITCHES (SW1) | |||||||
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| off | off | on | off | on | off | on | off |
Leave SW2 (10 switches) the way it is. Close the PRO Module's cover.
To install the NEWROCKIES PRO Module, connect it as following:
|
PRO Bypass |
Car Wires |
|
RED |
Splice into the Connector C201 Pin A16, Pink wire |
|
BLK |
Splice into the Connector C201 Pin A9 Black wire |
|
PPL |
Not used |
|
GRN |
Cut the wire in connector C201 pin A17 (DK BLUE) and attach to the dark blue towards the vehicle not the ignition cylinder. |
|
YEL |
Not Used |
|
WHT |
Not Used |
|
BRN |
Not Used |
IMPORTANT: If the security light remains illuminated but the car starts, cut the gray wire in Connector C201, A10 and tape the wires out of the way.
IMPORTANT: If your car still does not start, please follow the troubleshooting directions for PASSKEY 1/2/3 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.
The installation is completed.
0 Comments