2000-2005 Saturn L Series

Locate the BCM and install the PRO Full Bypass

The BCM is mounted on the top of the glove box.

1. Open the I/P compartment door.
2. Remove the I/P compartment lamp assembly by pulling on the lamp plunger.
3. Disconnect the lamp wiring harness from the I/P compartment.
4. Remove the retainer from the heater outlet assembly on the right side and remove the outlet.
5. Remove the I/P compartment door.
6. Slowly remove the I/P compartment bin, tilting the bin downward, to expose the BCM residing on the top of the I/P compartment.
7. Remove the BCM module from the I/P compartment by sliding the module out of the attaching slots.

 

There are 4 electrical connectors on the BCM.

 

Body Control Module J2

Cut the wire coming out of Connector J3, pin B7(YEL).

 

If the enclosure of your NEWROCKIES PRO Module is green and blue, please setup the switches as following (if enclosure is black, please submit a request to our support team for correct switch configurations): 

 

Open the NEWROCKIES PRO Module's cover (this will NOT void the warranty) by removing the 2 screws on the bottom. Inside there are 2 sets of switches.

 

Set SW1 (8 switches) as following:

DIP SWITCHES (SW1)
1	2	3	4	5	6	7	8
on	off	off	off	off	on	on	off

 

Set SW2 (10 switches) as following:

DIP SWITCHES (SW2)
1	2	3	4	5	6	7	8	9	10
off	off	off	off	off	off	off	on	off	off

 

To install the NEWROCKIES PRO Module, connect it as following:

Pro bypass	Car Wires
RED & WHT wires	Splice into the BCM connector J2, Pin A10, Pink.
BLK	Splice into the BCM connector J4  Black wire.
PPL	Unconnected
GRN	Unconnected
YEL	attach to the BCM connector J3, Pin B7 Yellow, toward the BCM. Tape the other side.
BRN	Splice  into the BCM connector J3, Pin B3 Orange/Black

 

 

 

 

Perform the re-learning procedure

1. Turn ON the ignition, with the engine OFF.
2. Attempt to start the engine, then release the key to ON (vehicle will not start).
3. Observe the SECURITY light, after approximately 11 minutes the light will turn OFF.
4. Turn OFF the ignition, and wait 30 seconds.
5. Repeat steps 1-4 twice more for a total of three times. Then on the third time, leave the key off for 30 seconds.
6. the vehicle is now ready to relearn the Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK).

 

Important: The vehicle relearns Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.

Start the engine (the vehicle has now learned the Sensor Data Code and/or password).

 

 

IMPORTANT: If your car still does not start, please follow the troubleshooting directions for Passlock 1/2 Systems before contacting our support team. This will make it easier and faster for us to handle your support questions and will enable us to serve you better.

 

The installation is completed.